![]() ![]() Please wait until the input field reappears.Ĩ. Then run the commands in the terminal as described on GitHub:ħ. If you use a different directory, you must take this into account in the commands below.Ħ. Open the terminal and switch to the appropriate directory.Ĭommand: CD /home/pi/pc-navtex-master/pc-navtex Download the file from Github using the button "Code" and "Download ZIP"ĥ. Sudo apt-get install libqt5serialport5-devģ. Installation of qt5 creator and libqt5serialport5-dev packages Connect the NASA USB PC Box to the Raspberry and supply it with powerĢ. If you can describe an easier and/or better way, please correct the instructions:ġ. As a Linux/Raspberry newbie, this is definitely not the best or right way. This guide was created by the user "Northern Comfort" from the sailing forum and is only intended as a suggestion and to describe the way in which the program became executable for him. The source code of the program is available on GitHub: Installation for Raspberry Pi Messages that are currently arriving are displayed immediately. When the program starts, the messages stored in the receiver are read. The program has filters for displayed messages, identifier of the sending station, identifier of the message subject, max. Incoming messages are stored in a SQLITE database. It can be used both on a PC and on single-board computers such as the Paspberry Pi. ![]() In contrast to the original software that runs under Windows, this program runs under Linux. ![]() Common USB/serial adapters can be used for this under Linux. The data is transferred via the serial interface. The PC NAVTEX program is used to display NAVTEX messages that are sent with the NAVTEX receiver " PC NAVTEX USB” of the company NASA were received. Jürgen from the Segeln-Forum took the trouble to create a Linux program for reading out the data for NASA's PC NAVTEX USB. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |